1 Preparing the countertop.
- Center the template on the counter so that it is parallel to the counter edge and that the installation hole will not interfere with the structure of the cabinet.
- Tape the template to the countertop to keep it in place and trace the cutout line on the template With a pencil.
2 Cutting the installation hole.
Drill a pilot hole and cut the countertop opening. Use the appropriate cutting tool for the surface you are cutting.
3 Preparing the sink.
- placed the sink underneath the countertop, cutout, and check if the cutout is fit for the sink, adjust the cutout, and if necessary, place a stand under the sink to facilitate installation and avoid dropping
- Place the mounting clips (not included) as shown in the attached template and mark the centers of the clip on the countertop.
4 Attaching the mounting clips
- Drill mounting holes in the clip center mark from the previous step. Insert the inserts in the holes so they are completely inside the hole. If necessary, gently tap the insert.
